HELP Help Me To Set Up My 4 in 1 DisEqC Switch

[Vadirocks]

Friends,


Please Help Me To Set Up My 4 in 1 DisEqC Switch

I Have Connected SES 7 In LNB1 & Connected ST-2 In LNB2

But I'm Getting Channels From SES 7 (LNB1 - Port1) Only & ST-2 Channels Shows No Signal

How Do I Enable Them I'm Using Solid HDS2-3000 FTA STB


I Have Tried Connecting ST-2 Alone In LNB2 But Still No Signal


Whatever I Connect In LNB 1 Only Works, All Other 3 Ports Not Working (Is There Anything Do I Need To Do In STB?)

 

[Mr.Bhat]

Well Vadi Follow these steps →

Bfore Power on connect ST2 Cable to ur desired port ie. u have sselected 2 so connect to 2.

Power on the Reciever > Press Menu > Go to Satellite List >

> Select ST2 [if its not in the list add new and name as ST2] >

> go to Antenna setup

> Edit like shown in the SS

> select the Port 2 > Press Exit and this saves automatically > Start scanning , If there is no TP then add new

> save.

 

[console]

Well Described ...

 

[IndianMascot]

Something new to learn from this thread.

 

[Vadirocks]

Thanks A Lot!

But Still I Have A Problem I Cannot See ST-2 Channels On My FTA STB & D2H HD STB Same Time Why?

Either I Have To Switch Of Solid STB Or Have To Change Channel To Other Sat

 

[Mr.Bhat]

Well how u connected to both ?

 

[Vadirocks]

Loop Out From Solid STB

 

[Mr.Bhat]

Thats the issue. Dont connect like this. It wont work if u watch channels from Vertical Pol channels in 1 and Horizontal in other.
use 2 WAY SPLITTER or AKA Power Divider.connect 1 out to D2H and other to Solid.

 

[Vadirocks]

Thanks A Lot Again

 

[Mr.Bhat]

1 thing u remember is 2 Way splitter might also not work and the best solution is >
Installing 2 Way output LNB . Take 2 Cables and connect separately to both Solid and D2H STB.